Reverse Components Angle távtartó gyűrű DH 1 1/8"

Fine tuning for your DH fork

With the DH Angle-Spacer (fork cone) for 1.5 "head tubes reduced to 1 1/8" fork shafts of double crown forks, the geometry of the bike can be fine-tuned.

It is possible to make the steering angle half a degree (- 0.5 °) flatter, which means that even more performance can be brought out of the bike on steep and difficult descents! The spacer replaces the conventional fork cone and is mounted between the fork crown and the headset. The Angle-Spacer can be used with any headset with 45 ° ball bearings. (45 ° ball bearings are installed in 95% of all bikes). The DH Angle Spacer is wider than the standard 1 1/8 Spacer (Ø 62mm) and therefore adapts perfectly to wide 1.5 "head tubes.

Assembly instruction

To use the Angle Spacer, simply take the fork out of the frame and then remove the existing fork cone / Crown Race from the fork crown. The Angle-Spacer is installed directly above the fork crown at the point where the old fork cone / Crown Race was previously. The use of the Angle-Spacer does not change the stability and stiffness of the fork in any way. It can be mounted on any bike without hesitation. This gives you a more modern geometry with more driving fun and safety.

Highlights

• Material: aluminum
• Inner diameter: 1 1/8 ``
• Outside diameter: 61.0mm
• Construction height: 10 mm
• Weight approx. 61 g (+/- 5% weight tolerance)

scope of delivery

• 1 x Reverse Angle Spacer (see item description for details)